Home › Tap drill chart › M12 x 1.5
M12 x 1.5 tap drill size
Use a 10.5 mm drill to tap M12 x 1.5 (fine pitch). The rule is major diameter minus pitch: 12 − 1.5 = 10.5 mm. Closest inch drill: Z (10.49 mm).
M12 x 1.5 thread specifications
| Thread | M12 x 1.5 ISO metric fine |
|---|---|
| Major (nominal) diameter | .4724 in / 12.00 mm |
| Pitch | 1.5 mm (≈ 16.9 threads per inch) |
| Recommended tap drill | 10.5 mm = .4134 in |
M12 clearance hole (ISO 273)
| Fit | Hole diameter |
|---|---|
| Fine (close) | 13 mm |
| Medium (normal) | 13.5 mm |
| Coarse (loose) | 14.5 mm |
A clearance hole lets the M12 bolt pass through freely. Drill the tap-drill size only in the part that gets threaded.
Tips for tapping M12 x 1.5
- Use cutting fluid, and with a hand tap back off about half a turn every turn or two to break the chip. Aluminium and soft materials are the exception: they tap cleanly with spiral-point taps.
- For blind holes, drill deeper than the thread you need. Allow at least 3–4 pitches beyond the last full thread for a plug tap (6.0 mm here).
- Thread engagement of 1–1.5 × the diameter (12.0–18.0 mm) is enough for most steel parts. Softer materials need more.