Home › Tap drill chart › 7/16-20
7/16-20 tap drill size
Use a 25/64 drill (.3906 in / 9.92 mm) to tap 7/16-20 UNF. That gives about 72% thread engagement. Closest metric drill: 9.9 mm.
7/16-20 thread specifications
| Thread | 7/16-20 UNF (fine) |
|---|---|
| Major (nominal) diameter | .4375 in / 11.11 mm |
| Threads per inch | 20 (pitch 1.27 mm) |
| Theoretical drill for 75% thread | .3888 in (9.88 mm) |
| Recommended tap drill | 25/64 = .3906 in |
Alternative drills and % of thread
Any of these drills will tap 7/16-20. Smaller drills give more thread but make tapping harder and raise the risk of breaking the tap, especially in stainless steel and in small sizes. 60–65% thread is common in tough materials. 75% is the general-purpose standard.
Tips for tapping 7/16-20
- Use cutting fluid, and with a hand tap back off about half a turn every turn or two to break the chip. Aluminium and soft materials are the exception: they tap cleanly with spiral-point taps.
- For blind holes, drill deeper than the thread you need. Allow at least 3–4 pitches beyond the last full thread for a plug tap (0.200" for 20 TPI).
- Thread engagement of 1–1.5 × the diameter (11.1–16.7 mm) is enough for most steel parts. Softer materials need more.