Home › Tap drill chart › #8-36
#8-36 tap drill size
Use a #29 drill (.1360 in / 3.45 mm) to tap #8-36 UNF. That gives about 78% thread engagement. Closest metric drill: 3.5 mm.
#8-36 thread specifications
| Thread | #8-36 UNF (fine) |
|---|---|
| Major (nominal) diameter | .1640 in / 4.17 mm |
| Threads per inch | 36 (pitch 0.706 mm) |
| Theoretical drill for 75% thread | .1369 in (3.48 mm) |
| Recommended tap drill | #29 = .1360 in |
Alternative drills and % of thread
Any of these drills will tap #8-36. Smaller drills give more thread but make tapping harder and raise the risk of breaking the tap, especially in stainless steel and in small sizes. 60–65% thread is common in tough materials. 75% is the general-purpose standard.
Tips for tapping #8-36
- Use cutting fluid, and with a hand tap back off about half a turn every turn or two to break the chip. Aluminium and soft materials are the exception: they tap cleanly with spiral-point taps.
- For blind holes, drill deeper than the thread you need. Allow at least 3–4 pitches beyond the last full thread for a plug tap (0.111" for 36 TPI).
- Thread engagement of 1–1.5 × the diameter (4.2–6.2 mm) is enough for most steel parts. Softer materials need more.